Polish Illumina 2.0 - 500gr
Step 2 Ultra Finish Polish
- Last step for closing the polishing process
- Provides an excellent finish
- Gives a deep shine
ILLÚMINA 2.0 the last step for closing the polishing process to give gloss and shine to the surface. It is a water-based product without silicones and fillers that, thanks to its anti-hologram formula, guarantees an excellent finish and gives a deep shine by removing collateral damage produced in the cutting stage.
ILLÚMINA 2.0 features a super glossy finish and at the same time good cutting properties. It replaces the old Step 3 in its ability to cut and eliminate holograms created by the previous correction step. It also replaces Step 4, but with a better finish than the previous one. It can be used on PPF protective films to remove signs of aging without damaging them. It is ideal for use with both orbital and rotary machines. The product is ideal on both hard and soft surfaces and deeply removes sanding marks up to P2500, without covering them, even on scratch-resistant clearcoats, OEM and repainted surfaces.
- Spread a little product at a time on a pad.
- With Rotary Press: work initially at 600-900 rpm, gradually rise to 1500-1800 rpm and in closing with light pressure at 600-900 rpm.
- With Rotorbitale: spread the product evenly at speed 1-2 over a 40x40cm area, increase to maximum speed to polish until polish is exhausted. Remove excess product with a microfiber cloth.
The product is not classified as hazardous according to the CLP regulation